Philips C244 Telephone User Manual


 
5
2Installation
Installation
Location
Place the charger on a flat, even surface. Do not install the
charger, handset and accessories in the proximity of:
Water, moisture or damp areas.
Sources of heat, direct sunlight or unventilated areas.
Devices which generate strong magnetic fields, electrical
appliances, fluorescent lamps, computers, radios, televisions
or fax and telephone terminals.
Areas where the handset can be covered, its ventilation is
impaired and liquid can get inside.
Areas where there is excessive dust and areas subject to
vibration, shock or extreme temperature fluctuations.
Install / keep the handset and accessories out of reach of small
children.
Commissioning
your Handset
Your handset is only operational after the batteries have been
charged. You can then use the handset to make and receive
calls.
Placing the batteries in the handset
The battery compartment is on the back of the handset. It
takes the three type AAA batteries which are supplied.
Please refer to the “Important Battery Information” on page 7.
Opening the battery compartment cover:
Insert a suitable item (e.g. the
top of a ballpoint-pen) into the
hole at the bottom of the com-
partment cover (1). Push it in
and lift the cover at the same
time (2).
Inserting the batteries:
Insert the batteries in the bat-
tery compartment, taking care
to observe the correct polarity.
The + - poles of the batteries
must correspond to the + -
markings in the battery com-
partment.