Filter
Top Products
IP Proprietary Telephone
Quick Reference Guide
Model No.
KX-NT136
Important Information
When using the KX-NT136, keep the following conditions in mind.
•
•
•
•
•
•
•
If the unit does not operate properly, disconnect the unit from the Ethernet® cable and then
connect again.
If you are having problems making calls, unplug the Ethernet cable and connect a known
working IP Proprietary Telephone (IP-PT). If the known working IP-PT operates properly, have
the defective IP-PT repaired by an authorized Panasonic Factory Servicentre. If the known
working IP-PT does not operate properly, check the Hybrid IP-PBX and the Ethernet cable.
Wipe the unit with a soft cloth. Do not clean the unit with abrasive powders or with chemical
agents such as benzene or thinner.
Use only the correct Panasonic handset.
Do not disassemble this unit. Dangerous electrical shock could result. The unit must only be
disassembled and repaired by qualified service technicians.
If damage to the unit exposes any internal parts, immediately disconnect the cable or cord. If the
power is supplied from the network to the IP-PT [Power-over-Ethernet], disconnect the Ethernet
cable. Otherwise, disconnect the AC adaptor cord. Then return this unit to a servicentre.
Never attempt to insert wires, pins, etc. into the vents or other holes of this unit.
Take special care to follow the safety suggestions listed below.
Safety
1) The unit should only be connected to a power supply of the type described in the Quick
Reference Guide or as shown on the label on the unit.
2) When left unused for a long period of time, the optional AC adaptor should be unplugged
from the AC outlet, if you are using Power-over-Ethernet, disconnect the Ethernet cable.
Installation
Environment
1) Do not use this unit near water, for example, near a bathtub, washbowl or sink. Damp
basements should also be avoided.
2)
Keep the unit away from heating appliances and devices that generate electrical noise,
such as fluorescent lamps, motors and televisions. These noise sources can interfere with
the performance of the unit. It also should not be placed in rooms where the temperature is
less than 5 °C (41 °F) or greater than 40 °C (104 °F). Allow 10 cm (4 in) clearance around
the unit for proper ventilation.
Placement
1) Do not place heavy objects on top of this unit.
2) Care should be taken so that objects do not fall onto, and liquids are not spilled into,
the unit. Do not subject this unit to excessive smoke, dust, moisture, mechanical
vibration, shock or direct sunlight.
3) Place the unit on a flat surface.
Trademark:
Ethernet is either a registered trademark or a trademark of Xerox Corporation in the United
States and/or other countries.
Document Version: 2006-02