Filter
Top Products
LIP-6812 & LIP-6830 Installer Guide
Rev 01.04 63 June 07
3.9 Default
The LIP-6812 & LIP-6830 Configuration can be returned to the Original Factory Defaults (refer
to Appendix A for the Default Configuration).
To return to the Default Configuration:
1) Press the button. If the LCD Menu is locked, use the unlock procedure (refer to
Section 3.3 Lock/Unlock Configuration).
2) Press button, or move cursor to 6.Default using the [Next]/[Prev] Softkeys, and press
the [ OK ] Softkey.
3) Press the [ Yes ] Softkey to set Configuration back to the Default values, or press the [ No ]
Softkey to cancel.
4) Press the button to exit from the menu.
Any Configuration customizing is lost upon return to the default configuration.
Default Configuration reset requires a reboot of the LIP-6812/LIP-6830; when you leave
the menu, you will receive a Reboot notice.
3.10 Reboot
After entry of the certain Configuration settings, the LIP-6812/LIP-6830 will require a reboot to
save the settings to active memory. These settings include the following:
- Network Configuration settings
- Call Server Address settings
- DSS Registration settings
- Software Update settings
- Default settings
1) Press the button. If the LCD Menu is locked, use the unlock procedure (refer to
Section 3.3 Lock/Unlock Configuration).
2) Press button, or move cursor to 9.Reboot using the [Next]/[Prev] Softkeys, and press
the [ OK ] Softkey.
3) Press the [ Yes ] Softkey to reboot the LIP-6812/LIP-6830, or press the [ No ] Softkey to
cancel this menu.
Will be set to default.
Are you sure?
[Yes ] [ No ]