Filter
Top Products
LIP-6812 & LIP-6830 Installer Guide
Rev. 01.04 D-2 June 07
Valid values are static and dhcp.
Default is dhcp.
To configure manually your IP settings, you must set this
parameter to static.
Note: Basic provisioning parameters are requested from the
local DHCP Server, as below:
DHCP Option #1 :Subnet Mask
DHCP Option #2 :Time offset in seconds of the local time
zone from GMT.
DHCP Option #3 :Default Gateway (router) IP Address
DHCP Option #6 :DNS Server IP Address
DHCP Option #42 :SNTP Server IP Address
DHCP Option #50 :IP address of the phone
DHCP Option #66 :TFTP Server Name
DHCP Option #150 :TFTP Server IP Address, has priority
over Option #66 when set
DHCP Option #160 :HTTPS URL for provisioning, has
priority over Option #66 and #150
dns1_address
IP address of the Primary DNS server used by the phone to
resolve names to IP addresses.
dns2_address
(Optional) IP address of the Secondary DNS server used by
the phone to resolve names to IP addresses. The phone
attempts to use Secondary DNS servers if Primary DNS
server is unavailable.
domain_name (Not used) Domain in which the phone resides.
tftp_server_address
IP address or URL of a TFTP server for provisioning.
tos
(Optional) Type of service (ToS) value for the media stream
being used.
Valid values are 00 to FF (Hex).
Default is 0.
pc_802_priority
(Optional) Establishes the IEEE 802.1 priority for Ethernet
frames from the LIP Phone PC port.
Valid values are 0 to 7.
Default is 3.
phone_802_priority
(Optional) Establishes the IEEE 802.1 priority for Ethernet
frames from the LIP Phone voice port including signaling
and voice packets.
Valid values are 0 to 7.
Default is 5.
pc_vlan_id
(Optional) Unique identifier of the VLAN of which the pc port
is a member.
• 1 to 4094
• 0 (disables VLAN)
Default is 0, disable.
phone_vlan_id
(Optional) Unique identifier of the VLAN of which the phone
port is a member.
Valid values are the following:
• 1 to 4094
• 0 (disables VLAN)
Default is 0, disable.