Nortel Networks CallPilot 100 Telephone User Manual


 
8 Initializing the CallPilot 100/150
N0008008 02
For information about how to set these parameters, refer to the documentation for your terminal or
terminal emulation program.
Changing the IP address using the terminal
1 Attach the serial cable to the serial port on the CallPilot 100/150.
2 Attach the other end of the cable to the serial port on the terminal or computer.
3 Ensure that your terminal or computer is powered up.
4 If you are using a computer, start your terminal emulation program.
5 Remove power from the CallPilot 100/150.
6 Reconnect power to the CallPilot 100/150.
The prompt
To change any of this, press any key within 5 seconds appears.
7 Press the Enter key.
The prompt
(M)odify any of this or (C)ontinue? appears.
8 Press the M key and press the Enter key.
The prompt
Do you want a LAN interface? appears.
9 Press the Y key and press the Enter key.
The prompt
This board’s LAN IP Address (0.0.0.0 = RARP) appears.
10 Type the IP address for the CallPilot 100/150 in a valid dotted format and press the Enter key.
The prompt
Subnet mask for LAN (0 for none) appears.
11 Type the Subnet Mask for the CallPilot 100/150 in a valid dotted format and press the Enter
key.
The prompt
Should there be a default gateway for packet routing? appears.
12 If the CallPilot 100/150 needs a next hop router, press the Y key and press the Enter key.
If the CallPilot 100/150 does not need a next hop router, press the N key, press the Enter key
and go to step 15.
The prompt
IP address of default gateway? appears.
13 Type the IP address of the next hop router in a valid dotted format and press the Enter key.
14 Press the Enter key until the following prompt appears:
(M)odify any of this or (C)ontinue?
15 Press the C key and press the Enter key.
Note: Steps 5 and 6 are used to force the CallPilot 100/150 to reboot. You can change
the IP address only while the CallPilot 100/150 is booting up.
Note: It will take approximately one minute for this prompt to appear.
Note: If you do not press a key within 5 seconds of this prompt appearing, repeat
steps 5 and 6.