Filter
Top Products
NEAX2400 IPX ISDN Features and Specifications
Page 22
NDA-24311, Issue 1
C-97 Call Pickup - Group - PRI
Service Conditions (cont’d)
9. When a single line station is originating/holding a call, the station can activate this feature.
10. This service cannot be activated from an ATTENDANT CONSOLE [A-3].
11. The following issues of firmware are required to be equipped on the circuit cards:
Interactions
1. CALL HOLD [C-6]: To pick up a call while engaged in a two-party connection, the station can switchhook
flash to place the other party on CALL HOLD [C-6] and dial the Call Pickup code. The first party is put
on CALL HOLD [C-6].
2. CALL BACK [C-1]: The call back station originator being called back cannot be picked up by a station
with the CALL PICKUP - GROUP feature. If the call back is directed to the terminating station, then Call
Pickup may be used to answer the call. Any other station attempting to pick up the call receives reorder
tone.
3. OUTGOING TRUNK QUEUING [O-2]: The OUTGOING TRUNK QUEUING [O-2] station being rung
back cannot be picked up by a station with the CALL PICKUP - GROUP feature. An attempt to pick up
the call results in receiving reorder tone.
4. Restriction: If assigned to a call pickup group, a station assigned as fully restricted or with inward
restrictions cannot use the Call Pickup feature.
5. THREE-WAY CALLING [T-2]: Call Pickup can be used only after a three-way conference has been
reduced to a two-party connection or the station has returned to an idle state.
6. STATION MESSAGE DETAIL RECORDING (SMDR) [S-10]: When a call is answered using the CALL
PICKUP - GROUP feature, the station dialing the call pickup code is recorded.
7. If more than one station line in a call pickup group is ringing, the individual call answered is selected by
the system. The system priority is based on a circular chain arrangement with first priority given to the
station following the station dialing the pickup code.
Circuit Card
PA-16ELCH Contact NEC Engineering for firmware requirements.
DAU (DLI) Contact NEC Engineering for firmware requirements.
DAU (DRU) Contact NEC Engineering for firmware requirements.