Filter
Top Products
NEAX2400 IPX ISDN Features and Specifications
Page 154
NDA-24311, Issue 1
C-153 Calling Name ID Presentation (CNIP)/ Connected Name ID Presentation (CONP)
C-153 Calling Name ID Presentation (CNIP)/
Connected Name ID Presentation (CONP)
General Description
This service (Supplementary Service - Calling Name Identification Presentation (SS-CNIP)/Connected Name
Identification Presentation (SS-CONP), based on ETS 300 238) allows the name display service through the Q-SIG
network. When the calling station places a call over the Q-SIG network, the Name ID of the calling station displays
on the D
term
LCD of the called station (CNIP service). Also, the called station Name ID displays on the D
term
LCD
of the calling station (CONP service). When the calling station is connected to a station in the CCIS network via
Q-SIG network (tandem connection), the CNIP/CONP service and NAME DISPLAY - SYSTEM - CCIS [N-37]
service interact to display the name information on the D
term
LCDs of both sides.
Operating Procedure
No manual operation is required.
Service Conditions
1. Q-SIG CIRCUIT SWITCHED BASIC CALL - ETSI VERSION [Q-4] should be available.
2. This service is available in the network where the end to end Q-SIG link is established or in the network
consisting of Q-SIG link and CCIS lines. However, in the following cases, this service is not available:
a.) when the call is routed over the office where Q-SIG Name ID notification service is not available.
b.) when the call is routed over the office where NAME DISPLAY - SYSTEM - CCIS [N-37] is not
available.
3. The routes to the office where Q-SIG Name ID notification service is available must be separated from
the routes to the office where the service is not available.
4. Even when the call is forwarded, the Name ID displayed on the calling station D
term
LCD during ringing
is that of the dialed station.
5. When the call is forwarded to the other office (e.g., CALL FORWARDING - ALL CALLS - CCIS
[C-45]), the Name ID displayed on the calling station D
term
LCD is that of the terminating station (target
station).
6. CONP service is available when the called station is busy or in line lockout status. However, when the call
is restricted, the Name ID does not display.
7. When the either of the calling/called station places the other on Consultation Hold and blind transfers the
call by Voice Call, the Name ID is not displayed to the transfer destination station.
8. This service and CALLING PARTY INFORMATION TRANSFER [C-112] cannot be activated together.
9. The Bearer Capability and data transmission specifications are as follows:
a.) Data transmission speed: 64 kbps
b.) Bearer capability: voice, 3.1 kHz audio, 7 kHz audio
10. If there is no Name ID for the calling/called station, the calling/called number displays instead of the Name
ID.