Filter
Top Products
NEAX2400 IPX ISDN Features and Specifications
NDA-24311, Issue 1
Page 119
Speed Calling - Station - PRI S-84
S-84 Speed Calling - Station - PRI
General Description
This feature allows a user to dial frequently called ISDN network numbers using fewer digits (abbreviated call
codes) than normally required. With this feature, a user can establish personal abbreviated codes.
Operating Procedure
1. Lift handset or press SPEAKER key; receive dial tone.
2. Dial the SPEED CALLING access code (one or two digits).
3. Dial the abbreviated call code (one or two digits); call is completed.
To operate from a D
term
1. Press Redial key; receive dial tone. The LCD displays:
2. Press the desired call code; call is completed.
Service Conditions
1. SPEED CALLING - STATION codes are programmed into RAM per Module Group.
2. Each abbreviated call code can store a maximum of 24 digits, including access codes.
3. A maximum of 100 stations per Module Group can be equipped with SPEED CALLING - STATION.
4. 100 memory blocks per Module Group are assigned for Speed Calling. A maximum of 10 numbers can be
stored in each memory block.
5. One station can be assigned 10 memory blocks for Speed Calling; therefore, it can be programmed for 100
numbers maximum.
6. TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION - 3/6-DIGIT [T-7] may or may not
be applied to Speed Calling, as desired.
7. LEAST COST ROUTING - 3/6-DIGIT [L-5] can be provided via Speed Calling access.
8. Each individual station equipped with this feature programs their own personal Speed Calling numbers.
9. If SPEED CALLING - STATION - PRI is assigned to a Module Group, SPEED CALLING - GROUP -
PRI [S-85] shares the same memory tables; so careful consideration should be taken when programming.
10. SPEED CALLING-STATION data is retained in memory, even if the system is reinitialized or in the event
of a power failure, by means of a hard disk for a system.
11. SPEED CALLING - STATION - PRI data remains even if system is reinitialized.
12. Stations can be added or removed from a group only via the MAINTENANCE ADMINISTRATION
TERMINAL (MAT) [M-18].
13. A user cannot dial the called party sub-address as abbreviated codes.
(Time Display)
LNR[ # ] / SPEED [ _ _ ]