Filter
Top Products
Administrator Tools
- 33 -
View a User Name
1. Press (SUPERKEY).
2. Press the third Personal key (counting upwards from the bottom on the 5312 IP Phone)
or the Line 3 key (counting upwards from the bottom right on the 5324 IP Phone). The
user display name (top) and user name (bottom) appears.
3. Press
(SUPERKEY) to return to the default display.
Device Parameters
To view the software version and the MAC address:
1. Press
(SUPERKEY), and then press >> until ADMIN TOOLS? appears on the
display.
2. Press OK. DEVICE PARAMETERS? appears.
3. Press OK. SOFTWARE VERSION appears.
4. Press Next to view either the software version or the MAC address.
• To view the software version, press REVIEW (the current software version
appears), then press OK. SOFTWARE VERSION reappears.
• To view the MAC address, press NEXT (MAC ADDRESS appears), then press
REVIEW. The current MAC address appears. Press OK. MAC ADDRESS
reappears.
5. Do one of the following:
• To return to the DEVICE PARAMETERS? menu, press EXIT.
• To return to the default display, press
(SUPERKEY).
Note: You can also view the MAC address using the Line 1 key (see View the IP and MAC
Addresses on page 34). You can also view the firmware version using the Line 2 key
(see View the Firmware Version on page 35).
Protocols
For information about supported communication and media protocols, access the Configuring
Protocols topic of the Administrator’s Web Configuration Tool Online (see Accessing the Web
Configuration Tool Online Help on page 7).
Enable/Disable Protocols
To enable/disable protocols using the Web Configuration Tool:
• Access the tool’s Protocols page.
Note: To access the Web Configuration Tool, HTTP must be enabled. If HTTP is disabled
and you need to access the tool, enable HTTP through the Superkey Menu Interface
(see procedure that follows below).
To enable/disable protocols using the Superkey Menu Interface: