Filter
Top Products
APPLICATIONS
CAR PAGE
DODGE
Van (full size) 1990-97.............................................1-3
KIT COMPONENTS
KIT FEATURES
Shaft and
DIN unit
provisions
99-6540
INSTALLATION
INSTRUCTIONS
Radio Housing
Re-connect the battery terminal and test the unit for proper operation. Mount the head unit/kit
assembly to the sub-dash with (2) screws. Place the Faceplate into the dash trim bezel and
mount with (3) 3/8" Phillips screws supplied.
7
5
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
6
Locate the upper dash tab in the sub-dash and
bend the tab down. ("A")
3
"A"
Faceplate
(3) 3/8" Phillips
Screws
TOOLS REQUIRED
Cutting tool
Drill
Phillips screwdriver
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 100103