Filter
Top Products
11
%E1 V.22bis auto-retrain enabled
%E2 Enable line signal quality monitor and
fallback/fallforward
%G_ %G0 Enable Auto Fall Forward/Back
%G1 Disable Auto Fall Forward/Back
-C_ -C0 Calling tone disabled
-C1 1300hz calling tone
-C2 V.8 and 1300hz calling tones enabled
3.5 MNP/V.42/V.42bis Commands
%A
n
Set auto-reliable fallback character to n
(where n = 0 to 127, ASCII). Requires the
\C2 setting. Default=13
%C_ %C0 Disable MNP Class 5 data compression
%C1 Enable MNP Class 5 data
compression
\A_ \A0 64-character maximum MNP block size
\A1 128-character maximum MNP block size
\A2 192-character maximum MNP block size
\A3 256-character maximum MNP block
size
\B
n
Send a 1/10 second line break to the
modem, where n = 1 to 9. At normal
connect, the default is 0
\C_ \C0 Do not buffer data during LAPM/
MNP handshaking
\C1 Buffer all data for 4 seconds, until
receiving 200 characters or until a packet
is detected
\C2 Do not buffer data; switch to normal
mode when fallback character is
detected
\G_ \G0 Disable DCE flow control
\G1 Enable DCE flow control
\J_ \J0 Disable serial port data rate
adjustment (keep high data rate
between DTE and modem,
regardless of modem-to-modem
data rate)
\J1 Enable serial port data rate adjustment
so serial data rate automatically adjusts
to match the modem-to-modem data rate
\K
n
Set break control, where n= 0 to 5.