Filter
Top Products
13
english
JABRA BT4010
cerTiFicaTion and saFeTy approvals
FCC
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Users are not permitted to make changes or modify the device in
any way. Changes or modications not expressly approved by Jabra
(GN US, Inc.) will void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device and its antenna must not be co-loaded or operating in
conjunction with any other antenna or transmitter.
Industry Canada
Operation is subject to the following two conditions: (1) This
device may not cause interference and (2) This device must accept
any interference, including interference that may cause undesired
operation of the device.
The term “IC:” before the certication/registration number only signies
that registration was performed based on a Declaration of Conformity
indicating that Industry Canada technical specications were met. It
does not imply that Industry Canada approved the equipment.