Kenwood NX-800H Two-Way Radio User Manual


 
9
BASIC OPERATIONS
SwiTching power on/oFF
Press and hold the switch for approximately 1 second to turn the transceiver
power ON. Press and hold the switch again to turn the transceiver OFF.
Transceiver Password
If the transceiver is password protected, “PASSWORD” will appear on the
display when the power is turned ON. To unlock the transceiver, enter the
correct password:
1 Select a character using the and keys.
If you are using a microphone keypad, you can enter the password by direclty
pressing the DTMF keys instead.
2 Press the key to enter the selected character.
This step is unnecessary when using a keypad.
3 Repeat steps 1 and 2 to enter the entire password.
Press the key or microphone # key to delete an incorrectly entered character.
Press and hold the key or microphone # key to delete all characters.
4 Press the key or microphone key to confirm the entry.
If you enter an incorrect password, an error tone sounds and the transceiver
remains locked.
The password can contain a maximum of 6 digits.
AdjuSTing The volume
Press the keys programmed with Volume Up/ Volume Down to adjust the
volume level.
SelecTing A Zone And chAnnel/group id
Select the desired zone using the keys programmed as Zone Up/ Zone Down.
Each zone contains a group of channels.
Select the desired channel/group ID using the keys programmed as CH/GID Up /
CH/GID Down. Each channel/group ID is programmed with settings for
transmitting and receiving.
Names can be programmed for zones and channels/group IDs. Each name can
contain up to 14 characters.
You can toggle the display between the zone and channel/group ID names and number
by pressing the key programmed as Display Format, or by accessing the Display Format
function through the Menu {page 12}.