HTC POP3 PDAs & Smartphones User Manual


 
8
No. Accessory Function
1 AC adapter Recharges the battery.
2 USB Sync cable Connects your device to a PC and synchronizes data.
3 Stereo headset Provides a volume control slider and a Send/End button. Press the Send/End button
to pick up a call or put a call on hold; press and hold the button to end the call.
Make sure you connect this headset when using the FM Radio since it uses the
headset as an antenna.
3. Getting Ready
Before you start using your device, you must install a SIM card and a charged battery. The SIM
card contains your phone number and service details, and it stores phonebook entries and your
messages.
If you need more storage for your device, you can also insert a microSD™ card inside the battery
compartment. Insert the microSD™ card first before the SIM card, since the storage card slot is
located underneath the SIM card slot.
Install the storage card and SIM card
1. Make sure your device is turned off.
2. Slide out the battery cover. If the battery is inside, remove by lifting it up from the upper right
side of the battery slot using your finger.
3. Slide the SIM card holder downward to unlock it, then lightly flip it open.
4. Pry open the storage card holder.
5. Insert the microSD™ card and the SIM card into the respective card holders, with their gold
contacts facing down. (The cut-off corner of the SIM card should match the cut-off corner in
the SIM card slot).