Filter
Top Products
22 Getting Started
1.2 Installing the SIM Card, Storage Card and
Battery, and Charging the PDA Phone
Always turn off your device before installing or replacing the SIM card,
storage card, and battery. You also need to remove the back cover before
you can install these components.
To remove the back cover
1. Make sure your device is turned off.
2. Hold the device firmly with both
hands and the front panel facing
down.
3. Push the back cover up with your
thumb until it disengages from the
device, then slide it up to remove.
Note To replace the back cover, align its tabs
with the holes on the upper side of the
device, then slide it down until it clicks
into place.
SIM card
The SIM card contains your phone number, service details, and phonebook/
message memory. Your device supports both 1.8V and 3V SIM cards.
Note Some legacy SIM cards may not function with your device. You should
consult with your service provider for a replacement SIM card. There may be
fees for this service.
To install the SIM card
1. Make sure your device is turned off.
2. Locate the SIM card slot, then insert
the SIM card with its gold contacts
facing down and its cut-off corner
facing out the card slot.
3. Push the SIM card completely into
the slot.
Cut-off
corner