Filter
Top Products
Rino
®
120 Owner’s Manual 17
UNIT OPERATION > RADIO PAGE
Setup Tones
Call Tone—When the Call key is pressed, an attention
tone is transmitted. This option allows you to choose one
of ten tones.
Roger Tone
—When the Talk key is released, a tone is
sent to signify the end of the transmission. This option
allows you to choose one of four tones or set the tone to
Off.
Ring Tone
—When an incoming transmission is received,
an attention tone sounds. This option allows you to
choose one of ten tones or set the tone to Off. The Ring
Tone will not sound again until there has been 45 seconds
of radio inactivity.
Vibrate—Choose from On or Off to have the unit
vibrate when an incoming transmission is received. Once
received, the unit will not vibrate again until there has
been 45 seconds of radio inactivity.
On/Off Tone
—Enable or disable the tone the unit makes
when it is turned on and off.
Message Tone—Choose from On or Off to have the unit
emit a tone when a message or note is received.
Setup Scanlist
Refer to “Scanning and Monitoring” previously in this
manual for complete information about this feature and
the options in this page.
Turn Radio/GPS On/Off
Press the Thumb Stick In on either of these two options
to toggle them from on to off. For example, to turn GPS
Off, press the Thumb Stick In when Turn GPS Off is
highlighted.
Setup Tones Page