Filter
Top Products
16 Rino
®
520/530 Owner’s Manual
UNIT OPERATION > RADIO PAGE
Setup Tones
Call Tone—When the Call button
is pressed, an attention tone is
transmitted. This option allows you
to choose one of 10 tones.
Roger Tone
—When the Talk
button is released, a tone is sent to
signify the end of the transmission. This option allows
you to choose one of four tones, or set the tone to Off.
Ring Tone
—When an incoming transmission is received,
an attention tone will sound. This option allows you to
choose one of 10 tones or set the tone to Off. The Ring
tone will not sound again until there has been 45 seconds
of radio inactivity.
Vibrate—Choose from On or Off to have the unit
vibrate when an incoming transmission is received. Once
received, the unit will not vibrate again until there has
been 45 seconds of radio inactivity. The unit also vibrates
at Power On when set to do so.
Message Beep—Choose from 19 options or Off to have
the unit emit a tone when a message or note is received.
Key Beep—Choose from four tones or Off to emit a tone
when a key is pressed.
Power Beep
—Enable or disable the tone the unit makes
when it is turned on and off.
Turn Warning (Early)—Choose from 19 tones or Off to
signal an upcoming turn on a route.
Turn Warning (Final)—Choose from 19 tones or Off to
signal the final turn on a route.
A “Set Quiet Mode” is available to mute all tones using
the Option Menu.
Setup Scanlist
Refer to “Scanning and
Monitoring” for complete
information about this feature
and the options in
this page.
Setup Tones Page
Setup Scanlist Page