Filter
Top Products
26
Clear the voicemail icon on your screen
Note:
This feature applies if you have voicemail service from your local phone service pro-
vider; it refers to the small envelope icon on your screen.
In Idle:
1. Press <OK/MENU> and <UP/DOWN> to select Settings.
2. Press <OK/MENU> and <UP/DOWN> to select “Clr voicemail”; display shows
“Reset VM icon?”
3. Press <OK/MENU> to conrm (or <CLEAR/MUTE> to cancel); display returns to
previous menu.
Note:
You can now access your Voicemail service by press-and-holding key “1” on your
numeric keypad.
REGISTRATION
IMPORTANT:
When you purchase a phone system, all handsets are
already registered to your base, so you do not need to register them.
Handset registration is only necessary when you buy extra handsets or if a handset has
become faulty.
You can register additional handsets to have up to ve handsets per base unit, with each
handset’s number (1 to 5) shown on its display.
To check whether a handset is registered, make sure mains power to the base unit is
switched on and the handset is within range. The handset’s display should show its
number and the <Antenna icon> should be steadily on. If the display shows “UNREG”,
you need to register the handset again using the following process:
On the cordless handset:
1. Press <MENU/SELECT> and <UP/DOWN> to select Settings; press
<MENU/SELECT>.
2. Press <UP/DOWN> to select “REGISTER”. Press <MENU/SELECT>.
Display shows “PRESS AND HOLD PAGE BUTTON”.
On the base:
3. At the same time, press and hold <PAGE/FLASH> for 4 seconds until the display
shows “Registering...”.
4. Handset displays “Registering... Please wait”.
USING YOUR CORDED BASE