Filter
Top Products
28 OL-8166-01
Starting or Joining a Meet-Me Conference Call
Meet-Me conferencing allows participants to join a conference by calling the conference number
directly, rather than waiting for the conference initiator to call them.
To start a Meet-Me conference, use the MeetMe softkey on your phone, then dial the Meet-Me phone
number provided to you by your system administrator. To participate in a Meet-Me conference, dial
the Meet-Me phone number at a specified time. Conference participants hear a busy tone if they call
into the conference before the conference initiator has dialed in. Once the conference initiator has
dialed in, the Meet-Me conference is established and can continue even if the conference initiator
disconnects.
Forwarding Your Calls to Another Number
You can use Call Forward All to redirect your incoming calls from your Cisco Unified IP Phone to
another number.
Tip Enter the Call Forward All target number exactly as you would need to dial it from your desk
phone. For example, enter an access code such as 9 or the area code, if necessary.
If you want to... Then...
Establish a Meet-Me
conference
Press NewCall or go off-hook and press more > MeetMe. Dial the
Meet-Me conference number. (See your system administrator for a list
of valid numbers.)
Note: Remember to inform participants about the conference number,
so they can dial in. However, participants will hear busy tone if they
call the conference number before you have dialed in.
Join a Meet-Me conference Dial the Meet-Me conference number provided by the Meet-Me
conference initiator.
You can join the conference only after the initiator has dialed in.
End a Meet-Me conference Hang up or press EndCall.
If you want to... Then...
Set up call forwarding
from your phone
Press more > CFwdAll and enter a target phone number. The screen
displays “Forwarded to <target number>.”
Cancel call forwarding
from your phone
Press more > CFwdAll. The “Forwarded to <number>” message
disappears.