Filter
Top Products
Configuring PGM Host and Router Assist
PGM Host and Router Assist Configuration Examples
IPC-501
Cisco IOS IP Configuration Guide
Note For clarity, extraneous information has been omitted from the examples in the following sections.
PGM Host with a Virtual Interface Example
Note Support for the PGM Host feature has been removed. Use of this feature is not recommended.
The following example shows PGM Host (both the source and receiver part of the PGM network layer)
enabled globally on the router and PGM packets sourced through virtual host interface 1 (vif1). PGM
packets can be sent and received on the vif and on the two physical interfaces (ethernet1 and ethernet2)
simultaneously.
ip multicast-routing
ip routing
ip pgm host
interface vif1
ip address 10.0.0.1 255.255.255.0
ip pim dense-mode
no ip directed-broadcast
no ip mroute-cache
interface ethernet1
ip address 10.1.0.1 255.255.255.0
ip pim dense-mode
no ip directed-broadcast
no ip mroute-cache
media-type 10BaseT
interface ethernet2
ip address 10.2.0.1 255.255.255.0
ip pim dense-mode
no ip directed-broadcast
no ip mroute-cache
media-type 10BaseT
PGM Host with a Physical Interface Example
Note Support for the PGM Host feature has been removed. Use of this feature is not recommended.
The following example shows PGM Host (both the source and receiver part of the PGM network layer)
enabled globally on the router and PGM packets sourced out of physical Ethernet interface 1. PGM
packets can be received on physical Ethernet interfaces 1 and 2 simultaneously.
ip multicast-routing
ip routing
ip pgm host
ip pgm host source-interface ethernet1
ip pgm host source-interface ethernet2
interface ethernet1
ip address 10.1.0.1 255.255.255.0
ip pim dense-mode