Cisco Systems 78-11741-02 Wireless Office Headset User Manual


 
Configuring IP Multicast Routing
IP Multicast Configuration Examples
IPC-457
Cisco IOS IP Configuration Guide
Router B Configuration
ip multicast-routing
ip pim dense-mode : or ip pim sparse-mode
ip pim neighbor-filter 1
access-list 1 deny 10.0.0.1
Load Splitting IP Multicast Traffic Across Equal-Cost Paths Example
The following example shows how to configure a GRE tunnel between Router A and Router B. Figure 75
illustrates the tunneled topology. The configurations follow the figure.
Figure 75 IP Multicast Load Splitting Across Equal-Cost Paths
Router A Configuration
interface tunnel 0
ip unnumbered Ethernet0
ip pim dense-mode : or sparse-mode or sparse-dense-mode
tunnel source 100.1.1.1
tunnel destination 100.1.5.3
!
interface ethernet 0
ip address 100.1.1.1 255.255.255.0
ip pim dense-mode : or sparse-mode or sparse-dense-mode
!
interface Serial0
ip address 100.1.2.1 255.255.255.0
bandwidth 125
clock rate 125000
!
interface Serial1
ip address 100.1.3.1 255.255.255.0
bandwidth 125
Router B Configuration
interface tunnel 0
ip unnumbered ethernet 0/5
ip pim dense-mode : or sparse-mode or sparse-dense-mode
tunnel source 100.1.5.3
tunnel destination 100.1.1.1
!
interface ethernet 0/5
ip address 100.1.5.3 255.255.255.0
ip pim dense-mode : or sparse-mode or sparse-dense-mode
!
interface serial 6/4
ip address 100.1.2.3 255.255.255.0
bandwidth 125
!
interface Serial6/5
Router A Router B
Source
S1
E0
E0/5
S0
Multicast
member
43284
S6/4
S6/5
Multicast GRE tunnel