Configuring IP Multicast Routing
IP Multicast Configuration Examples
IPC-448
Cisco IOS IP Configuration Guide
IP Multicast Configuration Examples
This section provides the following IP multicast routing configuration examples:
• PIM Dense Mode Example
• PIM Sparse Mode Example
• PIM Dense Mode State Refresh Example
• Functional Address for IP Multicast over Token Ring LAN Example
• PIM Version 2 Examples
• RTP Header Compression Examples
• IP Multicast over ATM Point-to-Multipoint VC Example
• Administratively Scoped Boundary Example
• IP Multicast Helper Example
• Stub IP Multicast Example
• Load Splitting IP Multicast Traffic Across Equal-Cost Paths Example
• IP Multicast Heartbeat Example
PIM Dense Mode Example
The following example configures PIM dense mode on Fast Ethernet interface 0/1 of the router:
ip multicast-routing
interface FastEthernet0/1
ip address 172.16.8.1 255.255.255.0
ip pim dense-mode
PIM Sparse Mode Example
The following example configures the Cisco IOS software to operate in PIM sparse mode. The RP router
is the router whose address is 10.8.0.20.
ip multicast-routing
ip pim rp-address 10.8.0.20 1
interface ethernet 1
ip pim sparse-mode