Cisco Systems 78-11741-02 Wireless Office Headset User Manual


 
Configuring IP Routing Protocol-Independent Features
IP Routing Protocol-Independent Configuration Examples
IPC-387
Cisco IOS IP Configuration Guide
Note It is not necessary to include definitions of all areas in an OSPF autonomous system in the configuration
of all routers in the autonomous system. You must define only the directly connected areas. In the
example that follows, routes in Area 0 are learned by the routers in area 1 (Router A and Router B) when
the ABR (Router C) injects summary LSAs into area 1.
Autonomous system 60000 is connected to the outside world via the BGP link to the external peer at IP
address 172.16.1.6.
Following is the example configuration for the general network map shown in Figure 63.
Router A Configuration—Internal Router
interface ethernet 1
ip address 192.168.1.1 255.255.255.0
router ospf 1
network 192.168.1.0 0.0.0.255 area 1
Router B Configuration—Internal Router
interface ethernet 2
ip address 192.168.1.2 255.255.255.0
router ospf 1
network 192.168.1.0 0.0.0.255 area 1
Router C Configuration—ABR
interface ethernet 3
ip address 192.168.1.3 255.255.255.0
interface serial 0
ip address 192.168.2.3 255.255.255.0
router ospf 1
network 192.168.1.0 0.0.0.255 area 1
network 192.168.2.0 0.0.0.255 area 0
Router D Configuration—Internal Router
interface ethernet 4
ip address 10.0.0.4 255.0.0.0
interface serial 1
ip address 192.168.2.4 255.255.255.0
router ospf 1
network 192.168.2.0 0.0.0.255 area 0
network 10.0.0.0 0.255.255.255 area 0
Router E Configuration—ASBR
interface ethernet 5
ip address 10.0.0.5 255.0.0.0
interface serial 2
ip address 172.16.1.5 255.255.0.0
router ospf 1
network 10.0.0.0 0.255.255.255 area 0
redistribute bgp 50000 metric 1 metric-type 1