Filter
Top Products
21
ENGLISH
Switching the handset on/off
– Press and hold the POWER ON/OFF button [9] until the handset turns off.
– To turn the handset on, just press the POWER ON/OFF button [9].
Auto answer
When the auto answer feature is enabled, you can answer the incoming call by just
lifting the handset from the base unit without pressing the CALL button [4].
Enabling the auto answer mode
1. Press the OK button [7], the LCD [2] will show: “PHONE BOOK”.
2. Press the [6] button, the LCD [2] will show: “HANDSET”.
3. Press the OK button [7].
4. Press the [6] button repeatedly until the LCD [2] shows: “AUTO ANS”.
5. Press the OK button [7], the LCD [2] will show: “ON” or “OFF”.
6. Using the [5] or [6] buttons, choose the appropriate mode.
7. Press the OK button [7] to confirm your selection and go to the previous menu item.
8. Press and hold the CANCEL button [9] to exit this menu item.
Base unit PIN Code
The base unit PIN code (Personal Identification Number) consists of four digits. The
PIN code is designed for prevention of illegal registration and base unit access. The
PIN code factory preset is 0000.
Changing the base unit PIN code
1. Press the OK button [7], the LCD [2] will show: “PHONE BOOK”.
2. Press the [6] button repeatedly until the LCD [2] shows: “BASE”.
3. Press the OK button [7].
4. Press the [6] button repeatedly until the LCD [2] shows: “CHANGE PIN”.
5. Press the OK button [7], the LCD [2] will show: “PIN?”
6. Using the dialing buttons [11], enter the current 4-digit PIN code (The factory preset
PIN code is 0000).
7. Press the OK button [7], the LCD [2] will show: “NEW PIN”.
8. Using the dialing buttons [11], enter the new 4-digit PIN code
9. Press the OK button [7], the LCD [2] will show: “RETYPE”.
10.Using the dialing buttons [11], enter the new 4-digit PIN code once again.
11.Press the OK button [7] to confirm your selection and go to the previous menu item.
12.Press and hold the CANCEL button [9] to exit this menu item.
Restoring the factory defaults
1. Press the OK button [7], the LCD [2] will show: “PHONE BOOK”.
2. Press the [6] button repeatedly until the LCD [2] shows: “BASE”.