Avaya SM236 PDAs & Smartphones User Manual

SM236 & CM936 Flexible Steel Swivel Dash or Console Phone or PDA Mount
Consumer Hotline:
(USA) (800) 841-0884
(INT'L) (626) 254-9005
Mon-Fri. 9am-5pm, PST
Arcadia, CA 91006 USA
Made in Taiwan
© Copyright 2007 Arkon Resources, Inc.
The Mobile Mounting Specialists
CM021-SB-2 (Dual T-tab)
CM021-SB-2 (Dual T-tab)
CM021-SB (Single T-tab)
CM021-SB (Single T-tab)
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Find a safe location on the dash or console to mount the
pedestal. Make sure the area is clean and dry. Use the included
alcohol pad to clean the mounting surface. Remove the adhesive
backing (A) under the circular base and firmly press into place.
After adhesive has bonded at room temperature (approx. 72°F),
allow 24 hrs prior to use for best results.
Adjust the direction of the pedestal by rotating the head on the
swivel base (B).
Adjust the angle of the pedestal head by bending the flexible
metal shaft of the pedestal (C).
Attach the device cradle to the pedestal by inserting the dual T-
tabs (D) of the pedestal into the T-slots of the cradle (E).
Installation Instructions
Step 1.
Step 2.
Step 3.
Universal Cradle Instructions
If necessary, adjust the support legs (K) by sliding them
laterally. These provide support for your device.
Place device on the support legs (K) and squeeze the side
grip arms (I) until they fit securely to the device.
Push the release button (J) in order to release the device from
the cradle.
Safety Precautions
Do not install Arkon products over an air bag cover or within the air
bag deployment zone. Arkon Resources, Inc. assumes no responsi-
bility of liability for injury or death as a result of car crashes and/or
air bag deployment.
Arkon Resources, Inc. is not responsible for any damages caused to
your car, your device, or yourself due to the installation or use of the
pedestal mount.