Filter
Top Products
GX2401c I/B version 09050A-1
15 09050A-1
OWNER’S MANUAL#GX2401c VER.09050A-1
PAGE:
15
English version
B.
IF THE HANDSET IS OUT OF THE BASE UNIT
1.
When the phone rings, press the TALK button on the handset. The LCD Display will
show "TALK" and the symbol will light steadily.
•
Start your conversation.
2.
To end your conversation, either press the TALK button or place the handset on the base
unit.
LAST NUMBER REDIAL
A. AFTER HEARING A BUSY TONE WHEN PLACING A CALL
1. If you get a busy tone, press handset TALK button to hang up.
2. Press the handset TALK button again and listen for a dial tone.
3. Press the handset RE / PA button. This will automatically redial the last telephone
number you called (Up to 31 digits).
B. WHEN THE HANDSET IS OFF THE BASE UNIT AND IN STANDBY MODE
1. Press the TALK button on the handset and listen for a dial tone.
2.
Press the RE / PA button. This will automatically redial the last telephone number you
called (Up to 31 digits).
STORING TELEPHONE NUMBERS INTO MEMORY DIALING DIRECTORY
In addition to your Call Records, you can store up to 20 speed dial names and telephone
numbers into memory and you can then dial any of the stored phone numbers. You can also
transfer a Call Record into the Memory Dialing Directory.
A. STORING TELEPHONE NUMBERS INTO MEMORY
1. Make sure that the handset is in the standby mode. The base and handset IN USE LED
indicator should be off.
2. Press and release the MEMO button. The handset will beep once.
3. Press the (+) or (-) button to locate an available location or enter a memory location.
There are 20 memory locations available. Memory location below 10 need a leading zero
such as 01, 02 to 09. If the memory location is available, the LCD panel shows the
memory location number and the "EMPTY" message. The flashing line or cursor
indicates that the phone is ready for data entry.
4. Enter the name, character by character. You can enter up to 15 characters. Locate the
character on the keypads 2 through 9. Press once to enter the first character, twice for
the second character, etc. Use or button to move the cursor back and forth
through the name entry line. To create a space between characters and words, press the
button twice after the last entered character.
NAME ENTRY TABLE
Key 1
st
2
nd
3
rd
4
th
5
th
1 & ( ) 1 space
2 A B C 2
3 D E F 3
4 G H I 4
5 J K L 5
6 M N O 6
7 P Q R S 7
8 T U V 8
9 W X Y Z 9
0 0
* * #
# space