Filter
Top Products
10. Press the Up or Down button until +TX appears flashing; then press the
Monitor (M) button to confirm the alarm transmit setting.
NOTE: This mode will only operate if the radio ID is enabled on and the
unit’s temperature triggers a temperature alarm.
TIME MODE
The Time mode provides you with a reliable clock which not only indicates the
time-of-day on a 12 or 24 hour basis, but also permits an alarm set capability
provided the beep tone feature is enabled. To access the time mode, proceed as
follows:
1. From the GMRS TWO WAY mode (CH and CODE displayed), press the
Function(F) button 5 times; TIME is momentarily displayed, followed by the
indication in AM or PM.
2. To set the clock to a 12 hour display, press the right menu button once; the
hours digits will flash. (To access the 24 hour display, press the Up or Down
buttons until the AM/PM indication disappears from the display; then proceed
with the hour/minute setting.)
3. Press the Up button or Down button; the hour indication will change between
1 and 12 accordingly. As the hour indication passes through 12 noon, the AM
indication changes to PM.
4. When the hour is set, press the right menu button again; the minutes
indication will flash.
5. Press the Up or Down button; the minutes indication will change between 00
and 59 accordingly.
6. Press the right menu button again; ALARM will appear with ON or OFF
flashing, together with the alarm icon (
).
7. Press the Up or Down button to set the alarm ON or OFF as desired.
8. If ON is selected, use the right/ left and Up/Down buttons to select the
desired time of alarm in the same manner as time-set in steps 2 through 5
above.
9. After all time functions have been selected and entered, press the Monitor (M)
button to confirm.
When the alarm time is reached, the unit will repeat four short beeps at 5-second
intervals; pressing any button during the alarm will snooze the alarm for 5 minutes.
To disable the alarm, repeat the above procedure and select OFF at step 7.
20