Filter
Top Products
128-6255A
12 of 16
-12-
To Transmit
1. Set the desired primary channel.
2. Press and hold the PTT (Push-to-Talk) button while speaking slowly and
clearly in a normal voice, approximately 2 to 3 inches from the microphone.
3. The transmit icon
( ) will illuminate while transmitting.
4. Release the PTT (Push-to-Talk) button when you finish speaking to receive
incoming signals. If enabled a “Roger Beep” tone will be heard on the receiv-
ing unit to indicate end of transmission.
To Receive.
1. Set the desired channel.
2. Adjust the volume control to the desired listening volume by using the up and
down buttons.
3. The transceiver will play strong received signals through its internal speaker
or through a headset, if so equipped.
Monitor Function
The monitor button can be used to play all signals present on a channel. This is
useful when communicating with other parties at extreme range.
The monitor function can be locked on by pressing the Monitor button for more
than 2 seconds. When the monitor lock has been activated, the LCD display will
indicate BUSY. Pressing the monitor button a second time will unlock the monitor
function.