Filter
Top Products
Charging the FR-1538:
Insert the charging transformer into a household electrical outlet and connect its
power jack to the socket on the rear of the charging stand. Simply placing the unit
into the charging stand will begin the charging process. The red LED on the front of
the charging transformer serves as a charge indicator. The charging stand will
charge two units simultaneously. Approximately 12 – 16 hours are required to fully
charge the batteries. Remember to turn your FR-1538 OFF before placing it into the
charging stand.
CAUTION: The charging stand in your kit is intended for use with the
rechargeable NiMH batteries supplied with the unit. Do not
attempt to recharge any other type batteries (Alkaline)
with the charging stand.
Controls:
Power On/Off and Enter ( ) Button (9):
Press and hold this button ( ) momentarily to turn the unit on. A short confirming
melody will sound and the unit will perform a brief self-test. To turn the unit off,
press and hold the button for a 2 second period. A short tone will sound before the
unit shuts off. The word bye bye in large and small script will appear momentarily
and then disappear.
Enter Button (9):
This button ( ) is also used to confirm options for operating modes during the
function edit mode. During main channel selection, a momentary press of this
button will access the CTCSS subcode for selection using the Up and Down buttons.
8
RED LED
CHARGING
INDICATOR
CHARGING
TRANSFORMER
TRANSFORMER
CONNECTOR
CHARGING
STAND