Audiovox FR1428 Two-Way Radio User Manual


 
-10-
Your FR-1428 has a unique circuit designed to dramatically extend the life of its
batteries. After 10 seconds of inactivity, the FR- 1428 will switch to battery saver
mode. While in battery saver mode, the battery saver mode indicator (
) is
present on the display, and the transceiver will remain ready to receive any
incoming transmissions while the battery saver mode is active. Pressing any of
the buttons will exit the battery saver mode and illuminate the display.
Pull out the face plate from the body of the transceiver using the groove located
at the bottom of the speaker grill.
Insert another face plate into the unit and install the two screws in the upper side
of the tray in the battery compartment. Replace the batteries and cover.
CHANGING SNAP-ON FACE PLATE (CONTINUED)
USING YOUR FR-1428
Turning the Transceiver On and Off ( )
Pressing the PWR button (7) for 2 seconds will activate the unit and ( on )
momentarily appears on the display followed by the frequency standby display.
The speaker will sound a beep tone to confirm the transceiver’s activation. To
turn the unit off, simply press and hold the power button for 2 seconds then
release it.
Volume Level
Audio reception volume is controlled by the Up (s) and the Down (t) button.
Momentarily pressing either button will increase or decrease the volume level.
The display will indicate “LE” followed by “- 1” (lowest setting to “- 8” highest
setting).
Call Button (8)
When the call button is pressed, the FR-1428 will transmit a 3-second ringing
sound to other transceiver’s tuned to the same channel. This feature can be
used to signal other parties that voice communication is desired. The call icon
(
) appears on the LED display while the call tone sounds.
BATTERY SAVER MODE