Filter
Top Products
Power Backup
-When a Spare Battery pack is installed in
the Ba§e Unit, the Audiovox DST961 uses
this battery to provide operational backup in
case of a power failure. If you have a fully
charged battery pack in the Spare Battery
charger and there is a power outage, you
will still be able to place and receive calls for
up to five hours.
Replacing a Drained Handset battery
The spare battery pa~ can also be used
to replace a drained H~dset battery pack
to ensure interrupted use. Be sure to put
the drained battery in the Spare Battery
charger for recharging.
Please note that the Spare battery pack
recharges at a slower rate than a battery
pack charging in the Handset. It takes 24
hours to fully charge a battery pack in the
Spare Battery charger.
GETTING STARTED
the Base Unit.
CHECK FOR A DIAL TONE
After charging the battery pack, rotate
the Base Unit antenna to an upright position.
Pick up the Handset, making sure the
Handset antenna is fully extended. Now
press TALK, you should hear a dial tone. If
not, see ' IN CASE OF DIFFICULTY
Fill in the telephone number card on the
base unit.
CAUTION:
1. Never install telephone wiring during a
lightning storm.
2. Never install telephone jacks in wet loca-
tions unless the jack is specifically de-
signed for wet locations.
3. Never touch uninsulated telephone wires or
terminals unless the telephone line has been
disconnected at the network interlace.
4. Use caution when installing or modifying
telephone lines.
SETTING UP YOUR AUDIOVOX DST961
Choose an area near an electrical outlet
and a telephone wall jack.
AC POWER ADAPTOR
Plug the AC power adaptor into an
electrical outlet and the DC connector to the
back of the base unit.
SETTING THE TONE/PULSE SWITCH
The TONE\PULSE switch is located on
the bottom of the base unit and is factory
set to TONE. If you have touch tone
service, do not change the switch setting.
If you have rotary (Pulse) service, set the
switch to PULSE.
CHARGE THE HANDSET BATTERY
PACK BEFORE USE
The battery pack recharges
automatically whenever the handset is in
the base unit. The battery pack must be
charged for 16 hours before using your
phone for the first time.
CONNECT TELEPHONE LINE CORD
Plug one end of the telephone cord into a
wall jack, and the other end into the back of
The Wall Mount adaptor is designed to fit
on standard Wall Mount plates. If you are
-6-
~
~