AT&T E2125 Cordless Telephone User Manual


 
28
Answering System Operation
1
Remote access
A 2-digit security code is required to access your
answering system from any touch-tone phone. This
code is “19” by default; see page 24 to change it.
Dial your telephone number from
any touch-tone phone.
2
When system answers, enter 2-
digit Remote Access Code (“19”
unless you have changed it).
3
Enter remote commands
(see list at right).
4
Hang up to end call and save all
undeleted messages.
Play messages
#2
Repeat or go back
#4
Skip to next message
#6
Stop
#5
Delete message
#9
Review announcement
#7
Record announcement
*7
to begin recording
#5
to stop recording
Record memo
*8
to begin recording
#5
to stop recording
Turn system off
#0
Turn system on
#0
Help Menu
#1
Exit
*0
Press to hear new messages (if none are
new, all play back).
Press to repeat current message. Press
twice (# 4 # 4) to hear previous message.
Press to skip current message and
advance to next message.
Press to stop any operation
(stop playback, stop recording).
Press during playback to delete current
message.
Press to review current outgoing
announcement.
Press * 7, wait for beep, then begin
speaking. Press # 5 to stop recording and
hear playback of new announcement.
Press * 8, wait for beep, then begin
speaking. Press # 5 to stop recording.
Press to turn off answering system.
Incoming calls will no longer be answered.
If off, system will answer after 10 rings. Enter
your access code, then press # 0 to turn on.
Press to hear list of features & commands.
End remote access call (or hang up).
NOTE: If you pause for
more than 10 seconds during
remote access, you will hear a
help menu listing all features &
commands. If you issue no
command for another 20 seconds,
the call will end automatically.
91-5743-10-00.E2125.RO.qxd 2/13/1950 7:21 PM Page 28