AT&T 902 Telephone User Manual


 
Part 2
© 1998 Philips Consumer Communications, L.P. All rights reserved.
Printed in Mexico. 848236212 Issue 1AT&T
User’s Manual for the
Two-Line Speakerphone 902
Fold open this manual for information about
this telephone’s installation and operation.
Please read Part 1 Important Product
Information, included in this package.
IN CASE OF DIFFICULT Y
Try calling the number you want
to enter into memory. When the
call is ended, press ,
and a memory button.
If someone lifts an extension
phone while you are storing num-
bers in memory, programming
might be interrupted. Make sure
all extensions are on hook while
storing numbers in memory.
You might not hear the confirma-
tion beep if the RECEIVER
(handset) volume is set too low, or
if you are in a noisy location.
If the number is more than 24
digits long, make sure you follow
the directions for “Dialing Long
Numbers.”
Do not put the phone on Hold
while storing numbers.
Problems With Line Status Lights
Make sure all plugs are connected
properly. Inspect the line cord
connections at the modular jack
and at the telephone. Also inspect
the coiled handset cord connections
at both ends.
Try replacing old bat t e r ies. See
“ B at t e ri e s ” in the Installation section.
Make sure the batteries are
correctly installed, and that the
battery contact surfaces and
battery case are clean.
If only one telephone line is
connected, make sure that only the
batteries for that line (as labeled
on the battery compartment) are
installed.
Telephone Does Not Ring
Make sure the RINGER switch
is set in the LO or HI position.
If there are several other
telephones on the same line, try
disconnecting some of the other
telephones. Having too many
telephones connected can also
create problems such as low ringer
volume, or impaired sound quality
during calls.
Other Problems
Make sure you have followed all the
instructions in this booklet. If you
continue to have problems, call
1 800 722-9125. If you cannot
correct the problem, disconnect the
telephone and refer to the warranty
information.