Filter
Top Products
6
NOTE: When the system is first connected to AC power, it begins an automatic
initialization routine. After this routine is complete, the Message Counter
flashes CL, indicating the clock needs to be set. See “Setting the Clock” in the
Answering System Set-up section of this manual.
7 Rotate the base antenna so it is fully upright.
8 Charge the handset batteries before use.
Place the handset in the base and charge the batteries for 4 hours. The
CHARGING light on the base goes on to show the handset is in the
right position to charge the batteries.
9 Check for dial tone.
After the batteries are charged, pick up the handset. Press P; the
PHONE light should go on and you should hear a dial tone. Press
P again to turn the phone off.
10 Set the dial mode.
If you have touch tone service, the phone is ready to use as soon as the
batteries are charged.
If you have dial pulse service you’ll need to change the dialing mode.
When the phone is off, press P, p, #, #, #, 3 to set
the dial mode to Dial Pulse. To return to touch tone dialing (with touch
tone service), press P, p, #, #, #, 8.
For Wall Installation
The wall mounting bracket is a wedge-shaped plastic piece attached to the bottom
of the base. You’ll need to attach this piece so the thickest end of the bracket is
facing the floor when you wall-mount the base.
1 Follow Steps 1 to 4 in Table/Desk Installation, except do not re-
attach the wall mounting bracket.
2 Connect the power cord to the telephone.
Plug the power cord into the jack labeled POWER on the back of
the base.
3 Guide the power cord from the jack through the straight channel
on the base.
Let the excess cord extend straight out of the end of the channel that is
farthest from the jack.
4 Connect the telephone line cord.
Plug one end of the line cord into the jack on the base. Guide the cord
from the jack through the curved channel on the bottom of the base.
Wrap any excess line cord around the 2 crescent-shaped tabs on the
underside of the wall-mounting bracket. (Make sure you leave enough
cord free to extend to the wall jack.)
INSTALLATION
7630_book.1AT&T 8/12/98, 6:28 PM6