AT&T 1485 Cordless Telephone User Manual


 
I N S TA L L AT I O N
Table/Desk Installation
¥
NOTE: Install this telephone away from electronic
equipment, such as personal computers,television
sets or microwave ovens. Avoid excessive heat,cold,
dust or moisture.
1 Connect the corded handset to the base.
2 Connect the telephone line cord. (figure a)
3 Connect the power cord to the base and
an electrical outlet not controlled by a wall
switch. (figure a) The answer ON/OFF light
goes on, and CL flashes in the message window.
Use only the power cord supplied with this
p ro d u c t . If you need a re p l a c e m e n t , call 1-800-
2 2 2 – 3 1 1 1 .
4 Check for dial tone.
Lift the handset, you should hear a dial tone.
¥
NOTE: For Wall Mount Installation see page 5 in the
User Manual.
Handset Charger Installation
1 Connect the power cord. Be sure to plug the cord
into an electrical outlet not controlled by a wall
switch.
2 Install the handset battery. Use NiCd Replacement
Battery 3301,SKU# 91076. (figure b)
3 Charge the handset battery.
Place the handset in the remote charging
stand.The CHARGING light goes on.
Charge the battery at least 12 hours.
4 Check for dial tone.
After the batteries are charged,lift the handset
and press ; you should hear a dial tone.
QUICK START GUIDE
2.4 GHz Corded Cordless
Telephone with Caller ID/Call
Waiting 1485/1185
Standard
electrical
outlet
Power Cord
Line Cord
figure b
figure a
Modular
telephone
jack
a) Remove battery
compartment
cover by
pressing on the
indentation and
sliding
downward.
c) Place battery pack in
compartment with
the wires in the
lower left corner,
along the bottom of
the battery pack.
b) Align two holes
in plug with
socket pins,
and snap the
plug into place.
d) Replace cover
by sliding it up
into place.