ArtDio IPF-2000 Telephone User Manual


 
IPF-2000 User Manual
18
For MGCP protocol:
The protocol service refers to Call Agent. Please check this box
according to system, and then enter Service Address field with the
IP address or domain name of the Call Agent.
Jitter Size
Setup jitter buffer size for the RTP voice packet. Jitter buffer ensures that
the received packets are in correct order. The range for the jitter size is
between 0 to 32 voice packets. The default setting value of 0. A bigger
jitter size can store more packets, but may cause more delay.
Service Type
The default service type is “common”. For other requests, please find the
service type in the drop down list.
Service Addr
Use H.323 protocol
If the “Use Service” option is checked, please enter the IP address
or the domain name of the gatekeeper.
If the “Use Service” option is not checked, please enter the IP
address or the domain name of the voice gateway.
USE MGCP protocol:
Please enter the IP address or domain name of the Call Agent.
Use SIP protocol:
If the “Use Service” option is checked, please enter the IP address or
domain name of the SIP Proxy Server in this field.
Service ID
Set service ID according to requirement of system.
NAT Traversal
When using a private IP to traverse the NAT, select one of the conditions:
Disable
When IPF-2000 is using a public IP, select “Disable”.
When IPF-2000 is using SIP protocol, and is using the Outbound
Proxy, select “Disable”.
Enable
Automatically check the public IP of the NAT router. When IPF-2000 is
using the private IP, please select “Enable”. After selecting Enable, the
NAT Addr. will automatically activate. Without special request, please
enter 0.0.0.0 in the NAT Addr field and properly configure the port on the
NAT router.
STUN
Use the STUN protocol. STUN enables a device to find out its public
IP address and the type of NAT service its sitting behind. It helps the
SIP traverse the NAT. Please also enter the IP address or domain
name of the STUN server in the NAT Addr field.
NAT Addr
When “STUN” or “Enable” is selected in NAT Traversal field, enter the NAT
proxy’s IP address. Otherwise, keep this field as 0.0.0.0.
NAT TTL
Define how many seconds a NAT traversal message is will be sent to the
NAT server. The default setting is 30 seconds.
Phone Number
With H.323/MGCP/SIP protocol used, enter the phone number of
IPF-2000.
Account
When using H.323 protocol to logon a Gatekeeper, please enter the
H.323 ID or H.235 account in this field.