Filter
Top Products
Chapter 3. Operation
61202076L1-1 TSU 600 User Manual 3-13
Terminal Mode Connection
The TSU 600 provides the front panel menus to a VT-100 type terminal.
This mode can be used to configure and monitor the unit. Initiate this
mode by typing <ctrl> PTT on the terminal once it is connected to the
Chain-In port. For detailed information on this method of control, see
Telnet Terminal Menus on page 8-1.
Telnet Connection
You can connect to the TSU 600 via telnet. Before attempting to connect
via telnet, first define the IP address, the default gateway, and subnet
mask using the front panel.
The dafault gateway and subnet mask are not used in SLIP mode.
When you begin the Telnet session, you will be prompted for a pass-
word. The default password is ADTRAN. You can change this pass-
word using the Management submenu. See Default Unit Passcode on
page 8-7, for details. The telnet session will time-out after a predefined
value that is also set in the Management Menu.
Only one telnet session can be active at one time.