Filter
Top Products
Chapter 3. Operation
3-12 TSU 600 User Manual 61202076L1-1
T-Watch PRO/EIA-232 Connection
To set up the TSU 600 to work with T-Watch PRO over a direct EIA-232
connection, the following steps are required:
SNMP
The ADTRAN TSU 600 supports the Simple Network Management Pro-
tocol (SNMP) through the chain-in (SLIP) interface or 10BaseT interface
(600e only). See Appendix B, Understanding SNMP for detailed informa-
tion.
To use SNMP with the TSU 600, do the following:
Step Action
1
Set the
Unit ID
and the
Passcode
using the Front Panel.
See Unit ID on page 6-3 and Change/Set a Passcode on page
6-3 for more details.
2
Set the Control Port rate to the same setting as the PC
Com port.
3
Connect the PC Com port to the Chain-In port on the
TSU 600 using the DB25 to modular adapter and 6-foot
modular cable.
4
Follow the installation instructions for T-Watch PRO to
start the program and connect to the unit.
Step Action
1
Set Control Port to SLIP for Chain-In Port or Normal for 10BaseT
(600e only).
2
Set the IP address, default gateway, and subnet mask through the
front panel.
The default gateway and subnet mask are not used in SLIP mode.
3
Load the appropriate MIB browser into the Network Management
Station (available on the ADTRAN webpage at http://www.adt-
ran.com). The MIB browser issues SNMP gets/sets to the TSU 600.