3D Connexion C11C536011 Two-Way Radio User Manual


  Open as PDF
of 6
 
Unpack
Unpack
If you have the EPSON Stylus Photo R300M, you need to attach the preview monitor.
1 Unscrew the cap from the end of the screw on the base. Then remove the screw.
2 Position the monitor into the base as shown, lining up the holes for the screw.
3 Push the screw through the holes (it can fit only one way) and screw the cap back onto the
end of the screw.
4 Remove the plastic cover from the printer.
5 Insert the tabs on the monitor base into the slots on the printer.
6 Remove the cap from the end of the monitor cable, then connect it to the preview monitor
port on the back of the printer.
1 Remove everything from the box.
2 Remove all the tape and
packing material from
the printer.
3 Open the output tray and lift the printer cover.
Then remove the tape.
Make sure the CD/DVD tray guide
is closed completely.
Turn On the Printer
Turn On the Printer
2
2
1 Flip open the paper support
and pull up the extension.
2 Open the output tray,
then pull out the extension.
3 Lift the printer cover.
4 Unwrap the ink cartridges.
5 Open the cartridge cover and
remove the paper insert.
6 Lower each cartridge into its holder with
the green circuit board facing the front.
The color of the cartridge label should
match the marker on the holder.
Then gently push each ink cartridge
down until it is firmly seated.
7 Close the cartridge cover.
8 Press forward on the front left corner of
the cartridge cover to lock it in place.
9 Press the Maintenance button
and close the printer cover.
CAUTION: Don’t turn off the
printer or interrupt charging
while the light is flashing or
you’ll waste ink.
A progress bar is displayed on the
LCD panel during ink charging.
10 After ink charging is finished,
press OK.
1 Plug the printer’s power cord into a grounded electrical outlet.
STOP: Do not connect the printer to your computer yet. Wait until you are instructed
to connect the USB cable in section 5, “Install Software.”
2 Press the power button
to turn on the printer.
CAUTION: Never use an external
switch, such as a wall switch or
power strip switch, to turn the
printer on or off.
Install the
Ink Cartridges
Install the
Ink Cartridges
3
3
CD position
check paper
Small CD
insert
Printer
User’s Guide
Don’t touch the green circuit
board or remove any labels.
EPSON Stylus Photo R300 Series
EPSON Stylus
®
Photo R300 Series
CPD-17016
4044644-00
XXX
Printer Software
CD-ROM
Start
Here
Start
Here
1
1
CD/DVD Tray
Quick Reference
Ink cartridges
Preview Monitor
(included with EPSON
Stylus Photo R300M only)
Preview Monitor Base
(included with EPSON
Stylus Photo R300M only)
Turn over
continue
Unscrew cap
Remove screw
Place monitor
in base and
line up holes
Remove cover
Attach monitor
base to printer
Connect to preview monitor port
continue
Make sure the
tray guide is up
next